Charnwood W715 Instructions d'exploitation télécharger pdf (Page 11)

Lower the upper blade guide

Remove the rip fence carrier

(shown here still in place)

Slide blade off upper and lower

wheels, bringing it out of the

machine via the slots in the rear

frame and the blade guard.

Reverse these steps to fit the new blade. Ensure that the teeth are at the front and pointing

down.

Position the blade between the guide pins. Tension and adjust the tracking as done during

the initial set up. Check and adjust, if necessary, the position of the two thrust bearings and

the guide pins.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Charnwood W715 Instructions d'exploitation Page 11